Author Topic: Exporting Calibration Images  (Read 2728 times)

Michael

  • Senior Software Engineer
  • Administrator
  • Hero Member
  • *****
  • Posts: 10145
    • View Profile
Exporting Calibration Images
« on: November 08, 2013, 10:53:01 am »
This post will give you the instructions to export a calibration file along with the images used to generate that calibration. These steps are for version 5 of Medmont Studio but the steps are very similar for version 4.

Enabling the E300 Instruments Tab.
If you haven't already, you will need to enable the E300 Instruments tab so you can see a list of all your E300 calibrations. To enable this tab follow these steps:

1. From the Ribbon bar menu select Configure > Studio > Preferences.
The Preferences dialog should now be displayed.
2. From the User Settings tab select Explorer Pane > E300.
3. Place a check/tick in the Display E300 Instruments checkbox.
4. Click on the OK button to apply the changes.

You should now have an E300 Instruments tab displayed at the bottom of your Patient Tree.



Exporting E300 Calibration Images
Once the E300 Instruments tab has been enabled, you will be able to navigate to the captured images and export them from Medmont Studio.

1. Click on the E300 Instruments tab at the bottom of the Patient Tree.
2. Find the node in the tree that corresponds to your instruments and expand it.
3. Once expanded you will see entries for each calibration you have performed. If you expand a calibration you have performed you will see a list of 5 images below it. Hold down Left Control Key and then Left click on the calibration date and time and each of the nodes under that calibration date.
4. From the ribbon bar menu click on the Application Button and select Export from the menu. This will prompt you to specify a location for the exported calibration file.





« Last Edit: November 08, 2013, 11:28:01 am by Michael »
Senior Software Engineer
Medmont Pty. Ltd.